User's Manual

Selex ES S.p.A.
Information contained in this document may not be used, applied or reproduced for any purpose unless agreed
by Selex ES S.p.A. in writing
7
2.2 Product Safety and RF Exposure Compliance
2.2.1 RF Exposure Compliance
The described product is intended for use in occupational/controlled conditions, where users have full
knowledge of their exposure and can exercise control over their exposure to meet R&TTE and FCC/IC
limits. This RBS is NOT authorized for any other use.
_________________________________________________________________________
- The minimum safe distance to antenna, depending on antenna gain, is shown in the
following table:
- La distance minimale de sécurité à l'antenne, en fonction de gain de l'antenne elle-même,
est illustré dans le tableau suivant.
Antenna Gain
Gain de l’antenne (dBi)
Safe distance
Distance de sécurité (cm)
8 (typ.)
450
15 (max.)
1000
_________________________________________________________________________
2.2.2 Electrostatic protection
When the equipment units are provided with the plate, shown in Figure 1 it means that they contain
components electrostatic charge sensitive.
Figure 1 Electrostatic sensitive equipment
In order to prevent the units from being damaged while handling, it is advisable to wear an elasticised
band (Figure 2) around the wrist ground connected through coiled cord (Figure 3) to the appropriate
point on the RBS (Figure 4)