Instructions / Assembly

Page 7 of 7
FLOATING FLOOR INSTALLATION
Make sure subfloor is tested for moisture content first and is properly prepared. Laying an
underlayment of 6-mil polyfilm with seams overlapped 8” is recommended for on or below
grade. Fasten seams every 18-24” with duct tape. Run the outside edges of film up the
perimeter of each wall 4” which will be trimmed after the installation is complete. Laying foam
underlayment with edges butted (not overlapped) and taped full length of the seam is
recommended for sound proofing.
Start first row with groove toward the wall. Glue end joints of the first row by applying a small
continuous bead of flooring adhesive to the bottom side of the groove. Clean up any adhesive
that is on the face by using a damp rag immediately. Always leave at least a 3/8” expansion
space between flooring and all walls and vertical objects such as pipes and cabinets. Use wood
or plastic spacers during installation to maintain this expansion space. Lay subsequent rows of
flooring by applying glue to side and end joints and fitting planks together with tapping block.
Remember to stagger end joints from row to row at least 8” apart. Clean up any adhesive that
is on the face of the floor by using a damp rap – DO NOT allow the adhesive to dry on the
flooring face as it is difficult to then remove without damage to the flooring.
AFTER INSTALLATION
If you decide to cover the floor, (to allow the other construction trades to continue working),
in order to protect the floors prior to final cleanup and turnover to the owner, use rosin paper
to cover the floors. DO NOT USE plastic film or other non-breathing type coverings as this can
cause the floor to become damaged from humidity and buildups. Remove expansion spacers
and reinstall base and/or quarter round moldings to cover the expansion space.
It is suggested that you buff the floor with lamb’s wool pads in order to “pull any splinters”,
remove any residues and handprints/footprints, etc.
Install any transition pieces that may be needed (reducer, T-moldings, nosing, etc.).
Do not allow foot traffic or heavy furniture on the floor for at least 24 hours (if glue-down or
floating).
Dust mop or vacuum your floor to remove and dirt or debris.
Get a copy of this products warranty from your local retailer.
DO NOT EVER WET MOP THIS FLOOR. DO NOT USE A WET SWIFFER. DO NOT USE SCENTED
CLEANING PRODUCTS ON THIS FLOOR AS IT CAN SOFTEN THE URETHANE COATING.
ONLY USE THE RECOMMENDED NEUTRAL CLEANERS. WHEN USING THE RECOMMENDED
CLEANER, THE FLOOR SHOULD BE WIPED DRY IMMEDIATELY IN EACH SECTION BEFORE GOING
TO THE NEXT SECTION. LIQUID SHOULD NEVER BE LEFT ON THE SURFACE OF THE FLOOR
ALLOWING IT TO AIR DRY.