User's Manual

OPERATION GUIDANCE
1)Fingerprint management
find the mechanical key hole, input the mechanical key. Rotating the mechanical key
clockwise for about 15-20 degrees and hold on the switching, hold it for about 2-3 seconds,
until the blue light lights up and releases it after hearing the sound of "di". Record
fingerprint: use your same fingerprint area to touch the fingerprint sensor 5 times in
multiple angles, if during the process of all the five times touching, blue light flash; and in
the fifth time, hearing a long -"di--" sound, the fingerprint recording succeed. Note: during
the recording time, if any single time of fingerprint sensor touching lead to a red-light flash
and heard short "di" sound, which means this pieces of recording is invalid. When this
happened, touch the fingerprint sensor again in multiple times with blue light lights up
until hearing the sound of "di" and release it.
Fingerprint identification to open the door: press the fingerprint, if the fingerprint is correct,
the green light will beep briefly, the motor will turn to unlock the door, and the motor will
turn off automatically 6 seconds later; If the fingerprint is not correct, the red light will beep
2 times.
1.2) Delete lock data
Insert the mechanical key, rotate about 15-20 degrees
clockwise and hold it for about 5 seconds, (firstly, the
green light will beep) until the red light is beeping , then
immediately return the mechanical key back, then will
see the long light-up green light is on with long "beep ~"
sound. All data stored are deleted.
2) Emergency mechanical key management (key hidden on handle)
Use special tool on the key chain to open the key cover of handle. Inserting the mechanical
key and rotate counterclockwise about 45 degrees to press the handle and open the door.