User's Manual

1) "Setup IP: Automatic" combo box: You can switch between automatic and

manual by pressing "Space-4" or "Space-1". If you select "Manual", you must

enter your IP address, subnet mask, gateway IP address, and DNS IP address.

You can move among these computer edit boxes by pressing "Space-4" or

"Space-1". Press "tab (Space-4-5)" to move to the next control.

2) "Network name (SSID)" computer edit box: Type the network ID in the

computer edit box.

3) "Network mode" combo box: You can select among "Infrastructure", and

"802.11 ad-hoc" mode by pressing "Space-1" or "Space-4".

4) "Network authentication mode" combo box: Select among "Open", "Shared",

"WPA-PSK", and "WPA2-PSK" by pressing "Space-1" or "Space-4".

5) "Data encryption" combo box: Select the data encryption method by pressing

"Space-1" or "Space-4". If you select "Open" or "Shared" in network

authentication mode, you can choose among "Disable" and "WEP". And if you

select "WPA-PSK" or "WPA2-PSK" in network authentication mode, either "AES"

or "TKIP" can be selected in the "Data encryption" combo box.

6) "The key is provided automatically" check box: If the "access point" does not

provide a key for users automatically, uncheck this check box by pressing

"Space". The default is checked.

7) "Network key" computer edit box: This is a computer edit box to type the

network key if the key is not provided automatically.

8) "Key index" edit box: This is an edit box to type the key number of the

wireless access point that matches the network key input.

9) "Confirm" button: Pressing this button applies the changes.

10) "Cancel" button: You can select this button to cancel the setup.

 Things to note: