User's Manual

55
The "Disconnect" menu item allows you to disconnect services with other
Bluetooth devices. You can access this item by pressing "Enter" on "disconnect"
from within the menu. Or you can activate it directly from the Bluetooth Service
List by pressing "Enter-D".
If there are no services connected and you activate this function, the unit says,
"There is no service connected".
3.3.2.1 Connecting a Service
To authenticate a service and connect to it, press "Enter" on the service. The
BrailleSense announces, "Connecting service". You are then prompted for a
"PIN code:" You must use ASCII characters when you type the pin code. This
edit box only appears when you have not previously connected to a service, and
a pin code is required by the device. You can exit the edit box or delete text you
have typed by pressing "Space-Z" and you are returned to the Bluetooth Service
List.
When you finish typing the pin code, press "Enter". The unit announces, "Please
wait for authentication". If the remote device is setup correctly, and has not been
set up to allow this device to always connect, the remote device also asks for a
pin code. Please be sure to enter the same pin code on both devices. If the
remote Bluetooth device pin code matches the pin code on the BrailleSense, the
service should authenticate. If connection is successful, the unit announces,
"PIN code authentication accepted".
You are then prompted, "Please wait. Access permission". If the remote
Bluetooth device does not give access permission, the unit says, "Connection
failed", and you are returned to the Bluetooth Services List. If the remote
Bluetooth device gives you access permission, the BrailleSense says
"Connection succeeded". If the connection succeeds, "Connected" is displayed