User's Manual

73 ProBee-ZE20S Series User Guide Rev.0.1
Response
<value><CR>
OK<CR>
OK<CR>
Default 0
Range 0 – 1
9.4.5 S45
Description
Get/Set the GPIO remote control mode. If any GPIO pin is set to digital input, a node
can control the I/O status of a remote node if the I/O pin of the node is set to digital
output. It is possible to use when GPIO monitoring is enabled.
Execute ATS45?<CR> ATS45=<value><CR>
Response
<value><CR>
OK<CR>
OK<CR>
Default 0
Range 0 – 1
9.5 End Device
9.5.1 S51
Description
Get/Set the poll timeout for a parent node in seconds. If an end device or a sleepy end
device does not send a poll request to its parent coordinator or router within the poll
timeout, the end device is removed from the child table.
Execute ATS51?<CR> ATS51=<value><CR>
Response
<value><CR>
OK<CR>
OK<CR>
Default 60
Range 0 – 4177920
9.5.2 S52
Description
Get/Set the sleepy end device poll period in milliseconds. Adaptive polling may allow
the sleepy end device to poll more rapidly for a short time when receiving RF data.
Execute ATS52?<CR> ATS52=<value><CR>
Response
<value><CR>
OK<CR>
OK<CR>
Default 100
Range 0 - 10000
9.5.3 S53
Description
Get/Set the sleep duration in quarter seconds. An end-device sleeps at this time and
turns off radio every sleep cycle. If a node sleeps over poll timeout of parent node, the
device will be removed from the child table.