User's Manual

20
configuration should be completed. Make sure that each IW06’s connect LED is on. At this point,
when both IW06’s are restarted the connection will be established automatically.
3.8. ParaniWizard
ParaniWizard is a Wizard program that will allow you to configure a pair of IW06’s for an automatic
connection. To make connection with Bluetooth devices other than IW06, use ParaniWIN or AT
commands on a terminal program.
In this example, we will refer to the two IW06’s as ESD1 and ESD2 respectively.
Install and run ParaniWizard.
Figure 3-10 ParaniWizard Step 1
Plug ESD1 into the serial port of the host computer and power on the unit. Click [Wizard Setting]
button to configure the serial port settings of ESD1. These settings must be the same as those of the
host system, to which ESD1 will be used. Click [Next].
Figure 3-11 ParaniWizard Step 2