User's Manual

Table 3-7 Pairing Process with other Bluetooth device by Pairing Button
SD1
Status
LED
Other Bluetooth Device
Status
1. Factory reset
Mode0
Mode LED turns on
2. Push pairing button
Mode3
Mode LED blinks 3 times
every 3 seconds
3. Inquiry and connect to SD1
4. Connected
Slave
Connect LED blinks
every second
4. Connected
Master
3.9. Software and Utility
This configuration software and utility for firmware update is included with the product, which also can
be downloaded from http://www.senaindustrial.com
Table 3-8 Configuration Software
Software
Purpose
Operating System
ParaniWIN
Configuration
MS Windows 98SE or Higher
ParaniUpdater
Firmware Update
MS Windows 98SE or Higher
3.10. ParaniWIN
ParaniWIN is a program that runs on Microsoft Windows for the configuration of Parani-SD1000U.
Install ParaniWIN on your computer. Plug a Parani-SD1000U into the serial port of the computer and
turn on the power. Run ParaniWIN.
Figure 3-2 Serial Port Setting
Set each option properly and click [Confirm]. If the settings of the Parani-SD1000U are different from
the ParaniWin, an error message will pop up. If the Parani-SD1000U is in the status of connection,
warning message will pop up. Then the current connection can be cancelled by [Disconnect] button on
the main window.