User's Manual

start>setting>control panel>add/remove programs. For more precise details on HyperTerminal
installations, please refer to Microsoft Windows Help section.
.
Figure 3-12 HyperTerminal
Attach Parani-SD1000U to usb port of host computer. Check Mode LED. (See 3.2)
Make sure that the Connect LED is turned off and the Stanby LED is turned on before attempting to
send any kind of AT commands to the Parani-SD1000U. Then launch HyperTerminal, it can usually be
found in start >programs >accessories >communication >HyperTerminal. Select the Serial port that
Parani-SD1000U is connected to.
Select the Serial port setting in the window displayed, please make sure the serial settings in
Hyperterminal are set to the same settings as the Parani-SD1000U’s serial settings.
To view the AT commands that are being typed, you will need to enable the local echo option. Go to
File->Properties->Settings->ASCII setup and select the “Echo typed characters locally” option.
For expanded AT commands, please refer to Appendix A. AT commands.
Example of AT commands:
at+btinfo?
00015B446655,SD1000Uv2.0.0-446655,MODE0,STANDBY,0,0,NoFC
OK
atd 000195000001
OK
CONNECT 000195000001