User's Manual

43
C.2 Enabling/Disabling of Response Signals OK, CONNECT &
ERROR
Parani10 will respond to users on the current status, success & failure of connections, and error
mode. Both Parani10_Manager and Terminal Programs will receive related response signals
from Parani10.
In some cases, various equipment may regard these four response signals incorrectly and react
inappropriately. To avoid these possible errors, users may disable the response signals via
Parani10_Manager or AT commands at Terminal.
1) By Parani10_Manager, check OFF at Signal pane at Device Setting panel to disable 4
response signals from Parani10.
2) By AT commands at your Terminal program.
ATS10=1 : Enabling/ON 4 signals
ATS10=0 : Disabling/OFF 4 signals
ATS10? : To see current status