User's Manual

This menu make easy pairing configuration of Parani-ESD. To use this menu, follow next steps.

Step 1. Connect the first ESD and then push the START button.

Step 2. Disconnect the first ESD, connect the second ESD and then push the Next button after setting

up Slave configuration.

Step 3. Disconnect the second ESD, once again connect the first ESD and then push the Finish

button. The pairing configuration finished. From now, when the ESD restarts the pairing connection

will be established automatically.

3.2.5. ParaniUpdater

Parani-ESD support firmware update. You can download new firmwares of Parani-ESD at

http://www.sena.com

. With ParaniUpdater, you can update firmware of Parani-ESD by selecting the

firmware image file and pushing Start button.

* Note: DO NOT power off Parani-ESD while the firmware update is progressing. It may damage the

firmware seriously.

Figure 3-11 ParaniUpdater Window

3.2.6. Terminal Program

A terminal program is an application that will enable a PC to communicate directly with a modem. If

you are using Windows 98SE or higher version of Windows, HyperTerminal program as it is included

as part of the operating system. Parani-ESD provides some extended AT commands for its

configurations on terminal program.

This manual will explain the method using HyperTerminal. If you need to install HyperTerminal, click

start>setting>control panel>add/remove programs. For more precise information, please refer to Help

of Microsoft Windows.

Attach Parani-ESD to serial port of host computer and power on.