User's Manual

3. Configuration

If users finished configuring network settings using serial console, now users need to select the

operation mode of Parani-MSP. Following three (3) ways can be used for selection of operation

mode:

1. Via Parani-MSP configuration software

2. Via Telnet (Control port)

3. Via Web browser (Internet Explorer, etc.)

In this chapter, guide to use Parani-MSP configuration software will be introduced.

How to configure via Telnet or Web browser will be introduced in Appendix.

3.1 Configuration via Parani-MSP software

3.1.1 When Parani-MSP is connected to PC directly

If users are going to connect Host PC and Parani-MSP directly using a crossed cable,

network settings as in the chapter 2.1 will not be required.

Parani-MSP has factory settings: Static IP 192.168.1.10/24 with DHCP server

For communication with Parani-MSP, just connect Parani-MSP and Host PC with a

crossed cable as below. Make sure Host PC to be configured using DHCP.