User's Manual

16
3.2. LED Indicators
RS232-Tx and RS232-Rx LED will flash accordingly when data is transmitted. For small data
transmissions, it may be hard to recognize the quick flashing action of the LED. Charge Led and Low
battery LED will be off, if you don’t use battery pack.
Table 3-2 The Parani-SD1000 LED Indicators
Indicator Mode LED Connect LED Charge LED Low battery
LED
Mode 0
Green
┏━━━━━
Mode 1
Green
(every 1 sec) ┏┓
Mode 2
Green
(every 3 sec) ┏┰┓
Mode 3
Green
(every 3 sec) ┏┰┰┓
Connected
Green
(every 1 sec) ┏┓
Charging
Red
┏━━━━━
Charging
Complete
Green
┏━━━━━
Low battery
Red
┏━━━━━
3.3. Serial Ports
The applicable settings for serial ports are as follows.
Table 3-3 The Parani-SD1000 Serial Port Settings
Serial Port Settings
Values
Baud rate
1200, 2400, 4800, 9600, 14400, 19200, 38400, 57600, 115200, 230400, 460800,
921600
Data bite
8
Parity
No parity, Even parity, Odd parity
Stop bit
1, 2
Hardware Flow Control
Use, No Use
The values in box are the factory defaults. The flow control setting is configurable only through dip
switch.
3.4. Data Bit
Parani-SD1000 supports only 8 data bit. In the case of 7 data bit and even/odd parity, use SD 8 data
bit and none parity. At this time, master and slave are Parani-SD, Parani-ESD or Parani-MSP series.
But 7 data bit and none parity is not support.