User's Manual

19
Step 5. Turn off and on. Mode LED blinks twice in green every 3 seconds.
Step 6. Now SD1 is waiting for a connection from the last connected Bluetooth device. The last
connected Bluetooth device can connect to SD1.
Table 3-7 Pairing Process with other Bluetooth device by Pairing Button
SD1 Status LED Other Bluetooth Device Status
1. Factory reset Mode0 Mode LED turns on
2. Push pairing button Mode3 Mode LED blinks 3 times
every 3 seconds
3. Inquiry and connect to SD1
4. Connected Slave Connect LED blinks
every second
4. Connected Master
3.9. Software and Utility
This configuration software and utility for firmware update is included with the product, which also can
be downloaded from http://www.sena.com
Table 3-8 Configuration Software
Software Purpose Operating System
ParaniWIN Configuration MS Windows 98SE or Higher
ParaniUpdater Firmware Update MS Windows 98SE or Higher
3.10. ParaniWIN
ParaniWIN is a program that runs on Microsoft Windows for the configuration of Parani-SD1000.
Install ParaniWIN on your computer. Plug a Parani-SD1000 into the serial port of the computer and
turn on the power. Run ParaniWIN.
Figure 3-2 Serial Port Setting
Set each option properly and click [Confirm]. If the settings of the Parani-SD1000 are different from the
ParaniWin, an error message will pop up. If the Parani-SD1000 is in the status of connection, warning
message will pop up. Then the current connection can be cancelled by [Disconnect] button on the
main window.