User's Manual

2.5. Reset to Factory Defaults

To set all the configuration settings to its factory default parameters, press the reset button, depicted in

Fig. 3-1. Press and hold (for at least 1 sec) the reset button with a narrow pointed tool like paper clip.

Reset works only when power is on.

2.6. Dipswitch

With the combination of 4 slot dipswitches, RS422/485 select, baud rate 9600 select, 485 echo and

termination on/off control can be set.

ParaniWIN or terminal program should be used to set these speeds. To set a baud rate not shown

below the dipswitches should be in the S/W Config setting. When in the S/W Config setting the baud

rate will go back to 9600 as default.

Table 1 Select by Dipswitches

422 485

Select

Table 2 Termination Select by Dipswitches

Off On

Termination

Table 3 485 Echo Control by Dipswitches

Off On

485 Echo Control

Table 4 Baudrate Settings by Dipswitches

AT Command 9600

Baudrate