User's Manual

2. Getting Started

This chapter describes how to set up the Parani-SD Series for the first time.

- 2.1 Panel Layout explains the panel layout.

- 2.2 Connecting the Hardware describes how to connect the power, the serial device, and the battery

pack (for SD200 only) to the Parani-SD Series.

Following items are pre-required to get started.

- One DC power adapter, USB power cable or DC power cable (included in the package).

- One PC with RS232 serial port.

- Terminal emulation program running on the PC

- One battery pack and two ‘AA’ batteries (optional accessory for SD200 only)

2.1. Panel Layout

This section describes the panel layout of the Parani-SD.

Figure 2-1 The panel layout of Parani-SD100