User's Manual

12
2. Getting Started
This chapter describes how to set up and configure the Pro Series.
- 2.1 Panel Layout explains the layout of the panel and LED indicators.
- 2.2 Connecting the Hardware describes how to connect the power, the network, and the
equipment to the Pro Series.
- 2.3 Accessing the Web Browser Management Interface describes how to access the console
port using a serial console or a Telnet or Web menu from remote location.
The following items are required to get started.
- One power cable (included in the package)
- One Serial data cable (included in the package)
- One Ethernet cable
- One PC with Network Interface Card (hereafter, NIC) and/or one RS232 serial port.
2.1. Panel Layout
2.1.1. PS110W Panel Layout
The PS110W has 5 LED indicator lamps for status display and 6 LED indicator lamps for sensitivity.
There is a factory reset switch front panel of PS110W and the user can use this switch to restore
factory default configuration.
Table 2-1 LED indicator lamps of the PS 110W
Lamps Function
Power
Turned on to RED if power is supplied
Status
Status
Turned on to Green if IP assignment and blinks if IP error. (Refresh 5 sec)
Ethernet
Blinks whenever there is any incoming and outgoing data stream through
the Ethernet of the PS110W
Wireless
Turned on to GREEN if WiFi is connected. Refreshed every 20 seconds.
Serial Port Serial
Blinks whenever there is any incoming and outgoing data stream through
the serial port of the PS110W
Sensitivity
Display AP’s sensitivity. Refreshed every 20 seconds
삭제됨: