Users Guide SMH10
FCC Information to User This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
Thank you for choosing SMH10, a Bluetooth Stereo Headset for your motorcycles. ….. The SMH10 features; - Bluetooth headset for Bluetooth mobile phone - Bluetooth Stereo headset for Bluetooth audio device - Bluetooth Stereo headset for Bluetooth GPS Navigation - Rider-to-Passenger Intercom - Bike-to-Bike Intercom up to 500m - Wired Stereo Headset for audio player by standard 3.5mm audio jack SPEC 1) Freq : 2402 ~ 2480 MHz 2) Channel: 79 CH 3) Channel Spacing: 1MHz 4) Battery: 3.
SMH10 Charging 1. Please make sure the SMH10 is fully charged before using the SMH10. To fully charge the SMH10, it takes about 2 hours by the supplied wall charger 2. The Red LED turns on while charging, and will turn off when the SMH10 is fully charged. SMH10 mounting to the helmet Configuration 1. Enable/Disable the Voice Activated Phone Answering Mode (Factory default: Enabled) If this mode is enabled, users can answer to an incoming call by simply saying a word loudly enough.
“Hello” loudly. If user and friend remain silent for 20 seconds, the intercom terminates automatically. Enable/Disable the Voice activated Intercom Mode - Press the Control Button and the Function Button for 3 second at the same time until the Blue LED flashes rapidly. - To enable, press Control Button for 3 seconds then the LED shows solid Buttons and LEDs 1. Control Button (Wheel Button) A. Power On/Off i.
2. Function Button A. Intercom initiate and terminate i. Tap the Function button to initiate intercom conversation. If the intercom established successfully, the user hears a series of high-tone beeps matching with the number of connected friend intercom. ii. The lasted connected friend intercom will be connected by default. iii. Tap the Function button to terminate intercom conversation. If the intercom terminated, the user hears a low-tone single beep B. Switching between friends Intercoms i.
