User's Manual

SMH10 Charging
1. Please make sure the SMH10 is fully charged before using the SMH10. To fully charge
the SMH10, it takes about 2 hours by the supplied wall charger
2. The Red LED turns on while charging, and will turn off when the SMH10 is fully
charged.
SMH10 mounting to the helmet
Configuration
1. Enable/Disable the Voice Activated Phone Answering Mode (Factory default: Enabled)
If this mode is enabled, users can answer to an incoming call by simply saying a word
loudly enough. For example, when users hear a series of beep by an incoming call, users
can answer the phone by saying “Hello” or any other words loudly. The factory default of
this mode is enabled. Users can disable this mode but if this mode is disabled, users have
to tap the Control Button to answer to an incoming call.
Enable/Disable the Voice activated Phone Answering Mode
- Press the Control Button and the Function Button for 3 second at the same time
until the Blue LED flashes rapidly.
- To enable, press Control Button for 1 second then the LED shows solid Blue for 3
seconds and you will hear a high-tone double beep.
- To disable, press Function Button for 1 second then the LED shows solid Red for 3
seconds and you will hear a low-tone double beep.
2. Enable/Disable the Voice Activated Intercom Mode (Factory default: Disabled)
If this mode is enabled, user can initiate intercom conversation with an intercom friend
by speaking any word of choice loudly enough without tapping the Function button. For
example, user can starts an intercom conversation with an intercom friend by saying