User's Manual

“Hello” loudly. If user and friend remain silent for 20 seconds, the intercom terminates
automatically.
Enable/Disable the Voice activated Intercom Mode
- Press the Control Button and the Function Button for 3 second at the same time
until the Blue LED flashes rapidly.
- To enable, press Control Button for 3 seconds then the LED shows solid
Buttons and LEDs
1. Control Button (Wheel Button)
A. Power On/Off
i. To power on, press control and function button the same time, and hold for 1
seconds until blue LED starts to flash
ii. To power off, press control and function button the same time, and hold for 1
seconds until red LED starts to flash
B. Phone Answer/End (in Stand-by mode)
i. To answer mobile phone call, tap the control button
ii. To answer mobile phone call without tapping the control button, speak loudly
any word, such as “Hello”. However, to do this, the Voice Activated Phone
Answering Mode must be enabled. By default this feature is set to be enabled.
To disable this feature, please refer to voice activation setting section.
iii. To end phone conversation, tap the control button.
C. Select friends Intercom (in Intercom mode)
i. Tap the Control Button to cycle between friends intercoms while intercom is on
D. Volume Adjusting
i. Turn the Control Button to up and down the volume
E. Mobile Phone and other Bluetooth Device Paring
i. Turn on the SMH10
ii. Press and hold the Control Button for six seconds until the red and blue LEDs
starts alternating
iii. Follow the paring process of the mobile phone or other Bluetooth device
according to their manual
iv. The LED shows solid blue for 3 seconds, if the pairing is completed.