SR10 Bluetooth® Two-way Radio Adapter SENA www.senabluetooth.
| SR10 CONTENTS INTRODUCTION ...................................................................................................................... 3 PACKAGE CONTENTS............................................................................................................ 4 INSTALLING THE SR10 ........................................................................................................... 5 POWERING ON/OFF AND CHARGING ...........................................................................
| SR10 INTRODUCTION Thank you for choosing the SENA SR10, Bluetooth Two-way Radio adapter. The SR10 is a Class 1 Bluetooth Two-way Radio adapter based on Bluetooth 2.1+EDR technology. You can connect various 2-way radios that are in the market today with the SR10 and connect wirelessly to a variety of Bluetooth communication headsets. The SR10 has two AUX ports that enable you to connect non-Bluetooth devices such as mobile phones, radar detector or GPS navigation.
| SR10 PACKAGE CONTENTS Main Unit Pairing Button Bluetooth Headset Pairing Mode Mobile Phone Pairing Mode PTT Button 2-way Radio Activation Power On/Off Button DC Power Charging Port AUX2 Mobile Phone, GPS Navigation, Radar Detector AUX1 GPS Navigation or Radar Detector Mini-DIN port for 2-way radio devices 2.5mm jack for wired PTT Button DC 5V Adapter USB Cable 3.
| SR10 INSTALLING THE SR10 Installing on the Handle Bar 1. Place the rubber on the back of the main unit. 2. Put the joint pad on top of the rubber, and tighten the screw. 3. Place the main unit on the handle bar, wind the rubber band, and hang it on the hook. Placing on the Belt / Pocket 1. Place the belt-clip on the back of the main unit, and tighten the screw. 2. Place the main unit on the belt with belt-clip.
| SR10 POWERING ON/OFF AND CHARGING To power on and off the adapter, you don’t need to press and hold any button for several seconds. Just short press the Pairing Button and the PTT Button simultaneously, and you will get quick on-and-off convenience. Powering On Press and hold the Pairing and the PTT button at the same time for about 1 second to turn the power on. When the power is on, the blue LED light turns on.
| SR10 PAIRING THE SR10 WITH BLUETOOTH DEVICES Before pairing with Bluetooth devices, SR10 must be in Pairing mode. SR10 can be switched to pairing mode by pressing the pairing button for 3 seconds. When SR10 is in pairing mode, the blue LED light will flash, and SR10 is now ready to pair with other devices. Bluetooth Headset Pairing 1. Turn on the Bluetooth Headset and enter pairing mode, following your Bluetooth 2.
| SR10 USING THE SR10 Using 2-way Radio Devices 1. When SR10 is turned on and connected with the 2-way radio device, the audio from the 2-way radio will be directly sent to your Bluetooth Headset. 2. To talk using the 2-way radio through SR10, press and hold the PTT button or wired PTT button until you finish talking. Installing Wired PTT Button 1. Installing on handlebar: Place the PTT button on the handlebar where you can easily reach it; wind up the rubber on handlebar and hang it on the hook. 2.
| SR10 For Wired Connection 1. Mobile phones must be connected to the AUX2 port for wired connection. 2. Other instructions are the same as for the wireless connection. Reset to Factory Default Settings 1. To restore the SR10 to factory default settings, press and hold the Pairing Button for 12 seconds until the LED shows solid red and blue. 2. Within 5 seconds, press the Pairing Button again to confirm reset. The SR10 will be 3.
| SR10 OPTIONAL ACCESSORIES To connect with two-way radio devices, device-specific optional accessory cables are required. The SR10 does not include these optional cables in its package; you need to purchase them separately.
| SR10 QUICK REFERENCE Button Pairing button + PTT button Description Duration Power-on on Solid blue Power-off 2 sec Solid red Bluetooth Headset pairing 3 sec Blue & Red alternatively flashing Mobile phone pairing 6 sec Red flashing Factory reset 12 sec Solid red Pairing button PTT Button 2-way radio transferring a call Bluetooth Headset - - connected Status LED Mobile Phone connected - Talking - 11 Solid blue
| SR10 BATTERY INFORMATION The SR10 has an internal, non-removable, rechargeable battery. Do not attempt to remove the battery from the device as you may damage the device. The battery can be charged and discharged hundreds of times, but it will eventually wear out. Recharge the battery only with SENA approved chargers designated for this device. Use of an unapproved charger may present a risk of fire, explosion, leakage, or other hazard.
| SR10 MAINTENANCE AND CARE The SR10 should be treated with care and the following suggestions will help you protect your warranty coverage. 1. Do not use or store the device in dusty, dirty areas. Its moving parts and electronic components can be damaged. 2. Do not store the device in hot areas. High temperatures can shorten the life of electronic devices, damage batteries, and wrap or melt certain plastics. 3. Do not store the device in cold areas.
| SR10 DISPOSAL The crossed-out wheel bin symbol on the product, literature, or packaging reminds you that all electrical and electronic products, batteries, and accumulators must be taken to separate collection at the end of their working life. This requirement applies to the European Union and other locations where separate collection systems are available.
| SR10 CERTIFICATION AND SAFETY APPROVALS FCC Compliance Statement This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: - This device may not cause harmful interference, and - This device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
| SR10 CE Declaration of Conformity This product is CE marked according to the provisions of the R&TTE Directive (99/5/EC). Hereby, SENA declares that this product is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC. For further information please consult http://www.senabluetooth.com. Please note that this product uses radio frequency bands not harmonized within EU.
| SR10 WAIVER AND GENERAL RELEASE By using the SR10, you waive any legal rights including the right to sue. Please read the following carefully before using the device. If you do not accept all terms of this agreement, you should immediately return the product for a full refund. By using the Adapter, you agree to be bound to this agreement and forfeit the right to sue.
| SR10 damages to or in respect to any person or property however caused, WHETHER ARISING FROM THE NEGLIGENCE OR OTHERWISE, and which may hereafter accrue to you on some future date as a result of said use, to the fullest extent permitted by law. 2. You fully understand and assume the risks in using the Device, including risk of negligent acts or omissions by others. 3.
| SR10 Two-Year Limited Warranty Sena Technologies, Inc. (“SENA”) warrants that this product (“Product”) shall conform to and perform in accordance with published technical specifications and the accompanying written materials, and shall be free of defects in materials and workmanship, for a period of two (2) year from the date of purchase by the first consumer purchaser of the Product.
| SR10 Return for Full Refund IF YOU ARE UNWILLING TO ACCEPT AND AGREE TO THE ABOVE CONDITIONS, YOU MAY RETURN THIS DEVICE TO SENA FOR A FULL REFUND, PROVIDED THAT YOU DO SO NO LATER THAN 14 BUSINESS DAYS FOLLOWING THE PURCHASE OF THE DEVICE AND SUBJECT TO THE WRAPPING BEING INTACT. WHEN DOING SO, PLEASE REFER TO THIS SECTION.
| SR10 WARNING SENA informs that using this device in public traffic may not be authorized by the law. Please check your local law and use this device only out of public traffic such as private properties or closed circuits. If the simultaneous use of both ear speakers while riding a motorcycle is prohibited by your local law, please use only a single ear speaker while riding. SENA denies any liability should you choose not to respect this warning.