User's Manual

| EXPAND
18
phone call
End intercom first Tap the Center Button
End phone call first
Press the Center Button for 2“
or
Wait for the called person to end the call
Start & End Three-way Conference Phone Call
14. INTERCOM FAILURE
When you try to start an intercom conversation with an intercom friend who is already having a conference intercom with
other riders or a mobile phone call, you will hear a low tone double beep signifying an intercom busy signal. In this case,
you have to try again later.
15. INTERCOM RECONNECTION
If your intercom friend goes out of range while having an intercom conversation, you may hear static noise and eventually
the intercom will be disconnected. In this case, the EXPAND automatically tries to reconnect the intercom every 8
seconds and you will hear high tone double beeps until the intercom is reestablished. If you don’t want to make a
reconnection, tap the Center Button to stop the attempt.
16. FAULT RESET
When the EXPAND is not working properly or is in faulty status for any reason, you may reset by pushing the pin-hole
reset button at the back of the headset main unit. Insert a paper clip into the reset pin-hole and press the reset button for
a second with light pressure. The EXPAND will be switched off, and you have to turn the system back on and try again.
However, this will not restore the headset to factory default settings.
17. FIRMWARE UPGRADE
The EXPAND supports firmware upgrade function. Please visit Sena Bluetooth web site at www.senabluetooth.com
to
check the latest software downloads.