User's Manual

| Snowtalk
18
Voice Prompt
“Factory reset”
Factory Default N/A
Execute Tap the (R) Button
To restore factory default settings on the Snowtalk, tap the (R) Button when you hear a voice prompt, “Factory reset”.
12.8 Exit Voice Configuration Menu
Voice Prompt
“Exit configuration”
Factory Default N/A
Execute Tap the (R) Button
To exit voice configuration menu and return to stand-by mode, tap the (R) Button when you hear a voice prompt, “Exit
configuration”.
Tap (L) Button Tap (R) Button
“Voice prompt” Enable / disable
“Sidetone” Enable / disable
“Advanced noise control”Enable / disable
“Delete All Pairings” Execute
“Factory Reset” Execute
“Exit Configuration” Execute
Voice Configuration Menu & Button Operations
13. FAULT RESET
When the Snowtalk is not working properly or is in faulty status for any reason, you may reset by pushing the pin-hole
reset button at the back of the headset main unit. Insert a paper clip into the reset pin-hole and press the reset button for
a second with light pressure. The Snowtalk will be switched off, and you have to turn the system back on and try again.
However, this will not restore the headset to factory default settings.
14. FIRMWARE UPGRADE