User's Manual
DWO-5
30
10.2 Intercom Reconnection
If your intercom friend goes out of range while
having an intercom conversation, you may hear
static noise and eventually the intercom will be
disconnected. In this case, the BiLT DWO-5
automatically tries to reconnect the intercom
every 8 seconds and you will hear high tone
double beeps until the intercom is reestablished.
If you do not want to make a reconnection, tap
the Center Button to stop the attempt.
10.3 Fault Reset
When the headset is not working properly or is
in faulty status for any reason, you may reset by
pushing the pin-hole reset button below the (+)
Button . Insert a paper clip into the reset pin-
hole and press the reset button for a second
with light pressure. The BiLT DWO-5 will be
switched off. Restart the system and try again.
This will not restore the headset to factory
default settings.
10.4 Factory Reset
If you want to restore the headset to factory
default settings, use the Factory Reset in the
congurationmenu.Theheadsetautomatically
restores the default settings and turns off.
Please refer to section
8.10
,
“Factory Reset”
for
more details.