User's Manual

Table Of Contents

Installation

There are three ways of installing the RC3.

1 2

Using the Clip

Using the Hook and Loop Fasteners

Using the Adhesive Tape

Hook Fastener

Loop Fastener

RC3

Quick Start Guide

Getting Started

Center Button

Battery Release Hole

Battery Slot

(-) Button(+) Button

Note:

•

When closing the battery slot, insert both ends of

the rubber rst.

•

To remove the battery, insert a paper clip through

the Battery Release Hole.

16.Aug

PAGE 1
RC3 Quick Start Guide Installation Battery Release Hole Using the Clip 1 (+) Button Center Button Using the Adhesive Tape There are three ways of installing the RC3. 2 (-) Button Using the Hook and Loop Fasteners Battery Slot 1 Hook Fastener Getting Started 2 Loop Fastener Note: • When closing the battery slot, insert both ends of the rubber first. • To remove the battery, insert a paper clip through the Battery Release Hole. 1 16.
PAGE 2
Button Operation Tap Battery Check Factory Reset Status LED Tapping Tap Double Tapping 1” Press for 1 sec - 70 ~ 100% Power On 0 ~ 30% Power On/Off ... - 30 ~ 70% - ... 8” (+) Button Tap (+) Button + Center Button 1” (-) Button Press ... Bluetooth Pairing Power On + Press Headset Control To control your headset using the RC3, please refer to the Quick Reference Guide for button operations on functions such as phone, music, and intercom.
PAGE 3
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received. Including interference that may cause undesired operation Note : This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules.