User's Manual

SPH10
12
systems use mobile phone prole for turn-by-turn
voice instruction. You can simultaneously use a
mobile phone and a GPS which uses mobile phone
prolebyoneofthefollowingprocedures.
6.4.1 Multipoint GPS Pairing
If you use GPS only for turn-by-turn voice instructions,
not for Bluetooth stereo music streaming, multipoint
pairing is recommended for the GPS connection.
Multipoint Bluetooth pairing allows the SPH10 to
connect twoHFP devices at thesame time: mobile
phone and GPS navigation. Follow the steps below to
pair the GPS using the multipoint pairing.
1. Turn on the headset and press the Jog Dial for 5
secondsuntiltheredLEDisrapidlyashingand
you hear multiple beeps.
2. Within 2 seconds, tap the Phone Button again, then
theLEDturnstoblueashingandthebeepsturn
to high tone double beeps. You will hear a voice
prompt saying “Multipoint pairing”.
3. Search for Bluetooth devices on the GPS navigation
screen. Select the Sena SPH10 in the list of the
devices detected on the GPS.
4. Enter 0000 for the PIN.
5.TheGPSconrmsthatpairinghascompletedand
the SPH10 is ready to use. You will hear a voice
prompt from the SPH10 saying “Your headset is
paired”.
6. If the pairing process is not completed within three
minutes, the SPH10 will return to stand-by mode.
The pairing diagram for multipoint GPS pairing is
showninthegurebelow.
Multipoint GPS Pairing
Smart Phone
SPH10
GPS
HFP
+
A2DP
Mobile Phone
Pairing
Multipoint
Pairing
HFP