User's Guide

| 3S PLUS

Certification and Safety Approvals FCC Compliance Statement

This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and

(2) This device must accept any interference received, including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class B digital device pursuant to part 15

of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential

installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in

accordance with the instructions, may cause harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference

to radio or television reception, which can be determined by turning the equipment on and off, the user is encouraged

to try to correct the interference by one or more of the following measures:

-Reorient or relocate the receiving antennae

-Increase the separation between the equipment and the receiver

-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

-Consult the dealer or an experienced radio/TV technician for help.

FCC RF Exposure Statement

The highest SAR value reported under this standard during product certification for use next to the head with the

minimum separation distance of 10mm is 0.317W/Kg. This transmitter must not be collocated or operating in

conjunction with any other antenna or transmitter. This product is compliance to FCC RF Exposure requirements and

refers to FCC website https://apps.fcc.gov/oetcf/eas/reports/GenericSearch.cfm search for FCC ID: S7A-SP84, IC:8154A-

SP84.

FCC Caution

Any changes or modifications to the equipment not expressly approved by the party responsible for compliance could

void user’s authority to operate the equipment.

Certification et homologation de sécurité Déclaration de conformité FCC

Cet appareil est en conformité avec la partie 15 des règles de la FCC. Son fonctionnement est soumis aux deux

conditions suivantes :

(1) Cet appareil ne doiㄴㄷt pas créer d’interférences préjudiciables et

(2) Cet appareil doit accepter toutes les interférences reçues, y compris celles qui pourraient entraver son bon

fonctionnement. Cet équipement a été testé et jugé conforme aux limites pour un appareil numérique de classe B,

conformément à la partie 15 des règles de la FCC. Ces limites sont conçues pour fournir une protection raisonnable

contre les interférences nuisibles dans une installation résidentielle. Cet équipement génère et utilise de l’énergie radio