User Manual
Table Of Contents
- 1 INTRODUCTION
- 2 PACKAGE CONTENTS
- 3 INSTALLING THE 20S ON YOUR HELMET
- 4 GETTING STARTED
- 5 PAIRING THE 20S WITH BLUETOOTH DEVICES
- 6 PAIRING WITH SELECTIVE PROFILE: A2DP STEREO OR HANDSFREE
- 7 MOBILE PHONE CALL MAKING AND ANSWERING
- 8 STEREO MUSIC
- 9 GPS NAVIGATION
- 10 SENA SR10, TWO-WAY RADIO ADAPTER
- 11 FM RADIO
- 12 AMBIENT MODE
- 13 VOICE COMMAND
- 14 INTERCOM PAIRING
- 15 TWO-WAY & MULTI-WAY INTERCOM
- 16 THREE-WAY CONFERENCE PHONE CALL WITH INTERCOM PARTICIPANT
- 17 GROUP INTERCOM
- 18 UNIVERSAL INTERCOM
- 19 FUNCTION PRIORITY
- 20 20S CONFIGURATION SETTING
- 20.1 Assigning Speed Dial
- 20.2 Enabling/Disabling Audio Multitasking
- 20.3 Setting Intercom-audio Overlay Sensitivity
- 20.4 Enabling/Disabling Navigation App Support
- 20.5 Enabling/Disabling Audio Boost
- 20.6 Setting Motion Sensor Sensitivity
- 20.7 Enabling/Disabling Voice Activated Phone Answering
- 20.8 Enabling/Disabling HD Intercom
- 20.9 Enabling/Disabling Eight-way Intercom
- 20.10 Enabling/Disabling Voice Prompts
- 20.11 Enabling/Disabling Sidetone
- 20.12 Enabling/Disabling Advanced Noise Control™
- 20.13 Delete All Bluetooth Pairing Information
- 20.14 Universal Intercom Pairing
- 20.15 Exit Voice Configuration Menu
- 21 RESET TO FACTORY DEFAULT SETTINGS
- 22 FAULT RESET
- 23 FIRMWARE UPGRADE
- 24 SENA BLUETOOTH CONNECTION CASE STUDIES
- 25 OPERATION QUICK REFERENCE
- CERTIFICATION AND SAFETY APPROVALS
- SAFETY INFORMATION
- PRODUCT WARRANTY AND DISCLAIMER
20S
10
5. Attach the headset main unit to the clamp unit. Slide the main
unit down onto the clamp unit until it clicks rmly into the bottom
portion of the clamp unit.
6. To remove the main unit from the clamp unit, press the Quick
Release Button to slide it off the clamp unit.
3.2 Glued Surface Mounting Adapter
If you have any problem equipping the clamp unit on the helmet for
any reason, you may use the glued surface mounting adapter to attach
the clamp unit on the external surface of the helmet.
1. Remove the speaker unit from the speaker port.
2. Remove the back plate of the clamp unit completely.
3. Remove the rubber pad and replace it with the thicker rubber pad
included in the package.
4. Put the speaker cable through the glued external adapter and
reconnect it to the speaker port.
5. Hook on the adapter to the clamp unit then screw in the glued
external adapter to the clamp unit.
6. Locate a proper surface on the helmet to attach the unit then clean
the helmet surface location with a moistened towel and allow to
dry thoroughly.
7. Peel off the cover of the adhesive tape of the adapter and attach
the unit on the proper surface of your helmet.
Note:
Sena recommends the clamp unit over the glued surface mounting
adapter. Even though the glued surface mounting adapter is provided for
convenience, Sena does not assume any responsibility for use of it. Users
may have to use the glued adapter at their own risk and responsibility.