User Manual
Table Of Contents
- 1 INTRODUCTION
- 2 PACKAGE CONTENTS
- 3 INSTALLING THE 20S ON YOUR HELMET
- 4 GETTING STARTED
- 5 PAIRING THE 20S WITH BLUETOOTH DEVICES
- 6 PAIRING WITH SELECTIVE PROFILE: A2DP STEREO OR HANDSFREE
- 7 MOBILE PHONE CALL MAKING AND ANSWERING
- 8 STEREO MUSIC
- 9 GPS NAVIGATION
- 10 SENA SR10, TWO-WAY RADIO ADAPTER
- 11 FM RADIO
- 12 AMBIENT MODE
- 13 VOICE COMMAND
- 14 INTERCOM PAIRING
- 15 TWO-WAY & MULTI-WAY INTERCOM
- 16 THREE-WAY CONFERENCE PHONE CALL WITH INTERCOM PARTICIPANT
- 17 GROUP INTERCOM
- 18 UNIVERSAL INTERCOM
- 19 FUNCTION PRIORITY
- 20 20S CONFIGURATION SETTING
- 20.1 Assigning Speed Dial
- 20.2 Enabling/Disabling Audio Multitasking
- 20.3 Setting Intercom-audio Overlay Sensitivity
- 20.4 Enabling/Disabling Navigation App Support
- 20.5 Enabling/Disabling Audio Boost
- 20.6 Setting Motion Sensor Sensitivity
- 20.7 Enabling/Disabling Voice Activated Phone Answering
- 20.8 Enabling/Disabling HD Intercom
- 20.9 Enabling/Disabling Eight-way Intercom
- 20.10 Enabling/Disabling Voice Prompts
- 20.11 Enabling/Disabling Sidetone
- 20.12 Enabling/Disabling Advanced Noise Control™
- 20.13 Delete All Bluetooth Pairing Information
- 20.14 Universal Intercom Pairing
- 20.15 Exit Voice Configuration Menu
- 21 RESET TO FACTORY DEFAULT SETTINGS
- 22 FAULT RESET
- 23 FIRMWARE UPGRADE
- 24 SENA BLUETOOTH CONNECTION CASE STUDIES
- 25 OPERATION QUICK REFERENCE
- CERTIFICATION AND SAFETY APPROVALS
- SAFETY INFORMATION
- PRODUCT WARRANTY AND DISCLAIMER
20S
9
English
2. Depending on the size and shape of your helmet, you may need
to change the thickness of the rubber pad between the clamp
plates. You can nd two extra rubber pads in the box. To increase
the overall thickness, attach the thinner one to the original rubber
pad or replace the original rubber pad with the thicker one.
3. Please adjust the direction of the microphone so that the n side
of the microphone is facing outward; away from your lips. You can
easily recognize it by touching the n with your ngers.
Fin
4. Place the helmet speakers along with the velcro pads, centered to
your ear, in the ear pockets of the helmet. If the helmet has deep
ear pockets, you can use the speaker pads to place the speakers
closer to your ears.
To enhance the audio quality, you can make use of the foam speaker
covers. Cover each speaker with the foam and attach the male
velcro pad at the back of the speaker. Then place the speakers in
the helmet as described above. Foam covered speakers work most
effectively when they are slightly touching your ears.
Male Velcro Pad
Foam Speaker Cover