User Manual

35
English
20S EVO
Mode Status Function Voice Command
Music / FM Radio
Next track (music) / next
preset (FM radio)
“Next”
Previous track (music) /
previous preset (FM radio)
“Previous”
Stop music / FM Radio
“Stop”
Note:
1. Voice command performance may vary based on the environmental
conditions including riding speed, helmet type and ambient noise. To
improve the performance, minimize wind noise on the microphone by
using the large microphone sponge and closing the visor.
2. To activate the voice command during non-stand-by functions, tap the
Ambient Mode Button or double tap the surface of the main unit.
3. If the 20S EVO is in stand-by mode for longer than one minute then
the microphone will automatically be disabled and the Voice Command
feature cannot be activated by saying "Hello Sena". The Voice Command
feature will need to be activated by tapping the Ambient Mode Button
once or double tapping the surface on the 20S EVO.
14 INTERCOM PAIRING
14.1 Pairing with Other 20S EVO Headsets for Intercom
Conversation
The 20S EVO can be paired with up to nine other headsets for
Bluetooth intercom conversation.
1. Turn on the two 20S EVO headsets (A and B) that you would like
to pair with each other.
2. There are two ways you can enter the two headsets into pairing
mode.
– Press and hold the Jog Dial of the headset A and B for 6 seconds
until red LEDs of both units start to ash rapidly. You will hear a
voice prompt saying “Intercom pairing”.
– Remove the two headsets from the clamps. Grab them with
each hand and shake them simultaneously until the green LEDs
of the both units start to ash rapidly.