Manual

43
ProBee
-
ZE20S User Guide Rev.1.
10
5 Digital and Analog I/O
5.1 GPIO (General Purpose Inputs and Outputs) Configuration
The ZE20S module has total 18 I/O pins. Among these pins, I/O pin 2 is assigned to factory reset only
and the user can use the rest 17 pins for general purpose inputs and outputs. The I/O pin assignments
are shown in Table 5-1. As shown in Table 5-1, some pins provide special functions built into the firmware.
Table 5-2 describes the special functions tied to the specific pins.
Table 5-1 Default I/O Pin Assignments
Pin Number GPIO Number Special Functions AI Enable
2 - Factory reset / Bootloader (SW_0) X
3 0 Permit joining / Wake-up (SW_1) X
4 1 UART_DTR X
5 2 UART_DSR X
6 3 UART_CTS X
7 4 UART_RTS X
8 5 X
9 6 X
10 7 X
11 8 X
32 9 O (AI_0)
31 10 O (AI_1)
30 11 O (AI_2)
29 12 O (AI_3)
28 13 O (AI_4)
27 14 O (AI_5)
24 15 Power LED (LED_0) X
23 16 Status LED (LED_1) X
The AT command below can be used to change the GPIO settings.
AT+GPIO=<values><CR> or AT+GPIO<number>=<value><CR>
, where <values> is a number between 0~5 as explained below:
0 Disabled (unmonitored digital input)
1 Digital input, monitored
2 Digital output, default low
3 Digital output, default high
4 Analog input, single ended (only valid for GPIO9~14)
5 Reserved for pin-specific alternate functionalities (See Table 5-2)