Manual

57
ProBee
-
ZE20S User Guide Rev.1.
10
 Close the USB_PWR jumper and open the RS_PWR and BATT_PWR jumpers.
 Connect a USB cable between a host computer and the coordinator
The AT commands for the coordinator are as follows:
AT+NODETYPE=1 # Set node type as Coordinator
OK # Response
AT+PANID=7772 # Set 16-bit PAN ID (7772)
OK # Response
6.6.2 Router Configuration
Hardware configuration for the coordinator is as follows:
 Set the ADC_2 and ADC_3 switch to TEMP_SENS and LIGHT_SENS
Figure 6-6 Hardware Configuration
The AT commands for the router are as follows:
AT+NODETYPE=2 # set node type as Router
OK # Response
AT+PANID=7772 # Set same 16-bit PAN ID (7772) as Coordinator
OK # Response
AT+GPIO=55555000000440055 # Set ADC_2 and ADC_3 as Analog Input
# OR
ADC_2
ADC_3