Manual

82
ProBee
-
ZE20S User Guide Rev.1.
10
8.6 Firmware Upload
8.6.1 Local Node
# enter the bootloader menu for uploading firmware. Note that UART of local
node should be set to 115200-8-N-1-N.
AT+BOOTLOAD<CR>
Press ENTER...
SENA ProBee Bootloader v1.0
1. Upload Firmware
2. Run
3. View Firmware info
PROBEE > # press “1” and upload ebl file by X-modem
begin upload
CCCCCCCCCCCCC
Serial upload complete # press “2” or reset after upload is done
8.6.2 Remote Node
# upload firmware to a remote node using 64-bit long address. Note that UART
of local node should be set to 115200-8-N-1-N.
AT+BOOTLOAD=1,00019500002FDC40<CR>
Please start .ebl upload image ...
CCCCCCCCCCCCC # upload ebl file by X-modem
Bootload Complete! # succeed to upload