Owner manual

63ProBee-ZS10 User Guide Rev.1.5
Range 0 – 99
7.3.3 S33
Description
Get/Set the transmission timeout in milliseconds. A sender retransmits data packet
after this time when transmission fails. (CAUTION: It is recommended to set this value
more than 1000 in broadcast/multicast data transmission.)
Execute ATS33?<CR> ATS33=<value><CR>
Response
<value><CR>
OK<CR>
OK<CR>
Default 500
Range 0 – 10000
7.3.4 S34
Description
Get/Set the indirect transmission timeout in milliseconds. It is the maximum amount of
time that the MAC will hold a message for indirect transmission to a child.
Execute ATS34?<CR> ATS34=<value><CR>
Response
<value><CR>
OK<CR>
OK<CR>
Default 3000
Range 0 – 30000
7.3.5 S35
Description
Get/Set the broadcast range. ZigBee specifies three different broadcast addresses that
reach different collections of nodes. Broadcasts are normally sent only to routers.
Broadcasts can also be forwarded to end-devices, either all of them or only those that
do not sleep. Broadcasting to sleepy end-devices is both significantly more resource-
intensive and significantly less reliable than broadcasting to routers.
0: send to all routers
1: send to all non-sleepy nodes
2: send to all nodes in the network
Execute ATS35?<CR> ATS35=<value><CR>
Response
<value><CR>
OK<CR>
OK<CR>
Default 2
Range 0 – 2
7.3.6 S36
Description Get/Set the maximum number of hops the message will be relayed. The message will