User guide

39
ProBee
-
ZS10 User Guide Rev.1.
1
.1
Range 00001000 - 03FFF000
5.4.2 AT+PANID or AT+PI
Description
Get/Set the 16-bit PAN ID. If it is set to 0s, the coordinator will select a random 16-bit
hexadecimal number as PAN ID, and the router/end-device will join any existing
network if it is allowed.
Execute AT+PANID?<CR> AT+PANID=<value><CR>
Response
<value><CR>
OK<CR>
OK<CR> or ERROR<CR>
Default 0000
Range 0000 – FFFF
5.4.3 AT+EPID or AT+EI
Description
Get/Set the 64-bit extended PAN ID. If the node is a coordinator and the EPID is set to
0s, it will take the rearranged IEEE address as random number.
Execute AT+EPID?<CR> AT+EPID=<value><CR>
Response
<value><CR>
OK<CR>
OK<CR> or ERROR<CR>
Default 0000000000000000
Range 0000000000000000 - FFFFFFFFFFFFFFFF
5.4.4 AT+GROUPID or AT+GI
Description Get/Set the 16-bit Group ID. It is used for multicast data reception.
Execute AT+GROUPID?<CR> AT+GROUPID=<value><CR>
Response
<value><CR>
OK<CR>
OK<CR> or ERROR<CR>
Default 0000
Range 0000 - FFFF
5.4.5 AT+POWER or AT+PW
Description Get/Set the TX power at which the RF module transmits conducted power.
Execute AT+POWER?<CR> AT+POWER=<value><CR>
Response
<value><CR>
OK<CR>
OK<CR> or ERROR<CR>
Default 3
Range -43 - 3
5.4.6 AT+STACK or AT+ZS
Description Get/Set the ZigBee stack profile value. This value must be set the same on all devices