User guide

41
ProBee
-
ZS10 User Guide Rev.1.
1
.1
AT+DSCAN=<scan duration><CR> or
AT+DSCAN=<scan duration>,<node type><CR> or
AT+DSCAN=<scan duration>,<node type>,<node name><CR>
Response
<node type>|<IEEE address>|<node ID>|<version>|<product name>|<node name>
List of the existing nodes and information…
OK<CR>
Range
Scan duration: 1 – 10
Node type: 0 – 4 (Zero indicates all node types.)
5.5.4 AT+NODETYPE or AT+NT
Description
Get/Set the node type. (0: none, 1: coordinator, 2: router, 3: end-device, 4: sleepy end-
device)
Execute AT+NODETYPE?<CR> AT+NODETYPE=<value><CR>
Response
<value><CR>
OK<CR>
OK<CR> or ERROR<CR>
Default 0
Range 0 - 4
5.5.5 AT+PERMIT or AT+PJ
Description
Permit other nodes to join the network. (0~254s, 255=continuance) An end-device
cannot perform it.
Execute AT+PERMIT<CR> AT+PERMIT=<value><CR>
Response OK<CR>
Range 0 - 255
5.5.6 AT+LEAVE or AT+LV
Description Leave the current network.
Execute AT+LEAVE<CR>
Response OK<CR>
5.6 End-device
5.6.1 AT+SLEEP or AT+SM
Description Enter the sleep mode immediately if the node is an end-device.
Execute AT+SLEEP<CR>
Response OK<CR>
5.6.2 AT+PARENTLA or AT+PL
Description Get the 64-bit IEEE address of the parent node.
Execute AT+PARENTLA?<CR>