User guide

46
ProBee
-
ZS10 User Guide Rev.1.
1
.1
Response OK<CR> or ERROR<CR>
5.10 Firmware Upload and Help
5.10.1 AT+BOOTLOAD or AT+BL
Description
Start bootloader to upload firmware. (blank: local, 1: passthru, 2: clone)
The device leaves the AT command line and enters the bootloader menu for uploading
new ProBee firmware. There’s no restrict to use local upload but a sleepy end device
cannot upload to remote node over the air. The current UART should be set
115200bps, 8 data bits, no parity, 1 stop bit and none flow control.
Execute AT+BOOTLOAD<CR> AT+BOOTLOAD=<number>,<IEEE><CR>
Response
Bootloader menu
…
Serial upload complete
Please start .ebl upload image ...<CR> or
Start cloning ...<CR>
Bootloader menu
…
Bootload Complete!
5.10.2 AT+HELP or AT+HP
Description Show all the available commands
Execute AT+HELP<CR>
Response
Available AT Commands
…
OK<CR>