User guide

ProBee

ZS10 User Guide Rev.1.

7.2.2 S22

Description

Get/Set the timeout to permit joining. It determines the time in seconds that the device

will allow other devices to join to it when it starts network but an end-device cannot

perform it. If set to 255, the device will always permit joining.

Execute ATS22?<CR> ATS22=<value><CR>

Response

OK<CR>

Default 60

Range 0 - 255

7.2.3 S23

Description

Get/Set the power boost mode of the adapter. If enabled, boost mode improves

sensitivity by 1dB and increases output power by 2dB, improving the link margin and

range.

Execute ATS23?<CR> ATS23=<value><CR>

Response

OK<CR>

Default 0

Range 0 – 1

7.3 Data Transmissions

7.3.1 S31

Description

Get/Set the application-ACK mode. If it is enabled, a node retransmits data packet

when it is failed to send. A node sends next packet after receiving ACK from receiver

node. This value must be set the same on the source and destination node for data

transmission.

Execute ATS31?<CR> ATS31=<value><CR>

Response

OK<CR>

Default 1

Range 0 - 1

7.3.2 S32

Description

Get/Set the transmission retries. If application-ACK is enabled, a sender tries to

retransmit up to this value.

Execute ATS32?<CR> ATS32=<value><CR>

Response

OK<CR>

Default 5