User guide

58
ProBee
-
ZS10 User Guide Rev.1.
1
.1
7.4.5 S55
Description
Get/Set the rejoin timeout. If it is enabled, an end-device tries to rejoin the current
network when contact with the network has been lost for setting value in seconds. The
most common usage case is when an end device can no longer communicate with its
parent and wishes to find a new one.
Execute ATS55?<CR> ATS55=<value><CR>
Response
<value><CR>
OK<CR>
OK<CR>
Default 10
Range 0 – 10000
7.4.6 S56
Description
Get/Set the end device poll period in seconds. Adaptive polling may allow the end
device to poll more rapidly for a short time when receiving RF data.
Execute ATS56?<CR> ATS56=<value><CR>
Response
<value><CR>
OK<CR>
OK<CR>
Default 5
Range 0 – 10000
7.5 Sink
7.5.1 S61
Description
Get/Set the sink node and the sink advertise period in seconds. When a node is
defined as a sink, it can multicast its address to the rest of the network. If set to 0, sink
advertise is disabled.
Execute ATS61?<CR> ATS61=<value><CR>
Response
<value><CR>
OK<CR>
OK<CR>
Default 0
Range 0 – 10000
7.5.2 S62
Description
Get/Set the period to send Many-to-One Route Reqest. Many-to-One Route Request
(MTOR) creates routes from every node in the network back to this node. It is useful
when this node acts as a sink node.
Execute ATS62?<CR> ATS62=<value><CR>
Response
<value><CR>
OK<CR>
OK<CR>
Default 0