User Manual

SMH10
14
1. Turn on the headset and press the Jog Dial for 5 seconds until the
redLEDisrapidlyashingandyouhearmultiplebeeps.
2. Within 2 seconds, tap the Phone Button again, then the LED turns
toblueashingandthebeepsturntohightonedoublebeeps.You
will hear a voice prompt saying “Multipoint pairing”.
3. Search for Bluetooth devices on the GPS navigation screen. Select
the Sena SMH10 in the list of the devices detected on the GPS.
4. Enter 0000 for the PIN.
5.TheGPSconrmsthatpairinghascompletedandthe SMH10 is
ready to use. You will hear a voice prompt from the SMH10 saying
“Your headset is paired”.
6. If the pairing process is not completed within three minutes, the
SMH10 will return to stand-by mode.
ThepairingdiagramformultipointGPSpairingisshowninthegure
below.
Smart Phone
SMH10
GPS
HFP
+
A2DP
Mobile Phone
Pairing
Multipoint
Pairing
HFP
Multipoint GPS Pairing
6.4.2 GPS Pairing as Mobile Phone
If GPS is not only used for turn-by-turn voice instructions but also is
your preferred Bluetooth stereo music source, you can pair the GPS to
the SMH10 by following the simple procedures in “6.1 Mobile Phone
Pairing”. When you do this, the SMH10 thinks the GPS is a mobile
phone. But the SMH10 can directly pair an additional mobile phone.