User Manual

SMH10
38
When you try to start an intercom conversation with an intercom friend
who is already having a conference intercom with other riders or a
mobile phone call, you will hear a low tone double beep signifying an
intercom busy signal. In this case, you have to try again later.
If your intercom friend goes out of range while having an intercom
conversation, you may hear static noise and eventually the intercom
will be disconnected. In this case, the SMH10 automatically tries to
reconnect the intercom every 8 seconds and you will hear high tone
double beeps until the intercom is reestablished. If you don’t want to
make a reconnection, tap the Jog Dial to stop the attempt.
19. INTERCOM FAILURE
20. INTERCOM RECONNECTION
1. To restore the SMH10 to factory default settings, press and hold
the Phone Button for 12 seconds until the LED shows solid red
and you hear double beeps. You will hear a voice prompt saying
“Factory reset”.
2.Within5seconds,presstheJogDialtoconrmreset.Theheadset
will be restored to factory setting and switched off automatically.
You will hear a voice prompt saying “Headset reset, good-bye”.
3. If you don’t press the Jog Dial within 5 seconds, the reset attempt
is canceled and the headset returns to stand-by mode. You will
hear a voice prompt saying “Canceled”.
21. RESET TO FACTORY DEFAULT SETTINGS