Operation Manual

SMH10
16
• Intercom Failure
When you try to start an intercom conversation with an Intercom Friend who
is already having a 3-way conference intercom with other persons or a mobile
phone call, you will hear a low tone double beep signifying a busy signal. In
this case, you have to try again later.
• Intercom Reconnection
If your Intercom Friend goes out of range while having an intercom conversation,
you may hear static noise and eventually the intercom will be disconnected. In this
case, the SMH10 automatically tries to reconnect the intercom every 8 seconds
and you will hear high tone double beeps until the intercom is reestablished. If you
don’t want to make a reconnection, tap the Jog Dial to stop the attempt.
2. By Bluetooth Wireless Stereo
The Bluetooth audio device must be paired with the SMH10 by following the
Bluetooth Audio Device Pairing instructions described in the previous chapter.
The SMH10 supports the Audio/Video Remote Control Profile (AVRCP), so if your
MP3 Jack
•
Stereo Music
You can listen to stereo music in either way: with the enclosed stereo audio cable
or by Bluetooth wireless stereo.
1. By Stereo Audio Cable
Plug your stereo MP3 player directly to the SMH10 by using the enclosed 3.5mm
stereo audio jack cable. To adjust the volume, rotate the Jog Dial on the headset.
You may adjust the volume on the MP3 player also.