www.senabluetooth.
SMH10 CONTENTS INTRODUCTION PACKAGE CONTENTS INSTALLING THE SMH10 ON YOUR HELMET POWERING ON/OFF AND CHARGING • Powering On • Powering Off • Charging • Low Battery Warning PAIRING THE SMH10 WITH BLUETOOTH DEVICES • Mobile Phone Pairing • Bluetooth MP3 Player Pairing • Bluetooth GPS navigation Pairing PAIRING WITH SELECTIVE PROFILE: A2DP STEREO OR HANDSFREE • A2DP Stereo Music Only • HFP for Phone Call Only PAIRING WITH OTHER SMH10 HEADSETS FOR INTERCOM CONVERSATION USING THE SMH10 • Volume Adjustment •
SMH10 English INTRODUCTION The SMH10 features: • Bluetooth hands-free for Bluetooth mobile phones • Bluetooth stereo headset for Bluetooth audio devices such as MP3 players Thank you for choosing the SENA SMH10, Bluetooth Stereo Headset and Intercom • Bluetooth headset or stereo headset for Bluetooth GPS navigations for motorcycles.
SMH10 • Speaker-Microphone Clamp Unit PACKAGE CONTENTS Speakers • Headset Main Unit DC Power Charging & Firmware Upgrade Port Microphone Phone Button • Making and Answering a mobile phone call • Entering into Mobile Phone Pairing Mode • Entering into Bluetooth Audio Device Pairing • DC Power Charger Mode (MP3, GPS navigation) • Entering into Voice Activated Phone Answering Setting Mode Jog Dial • USB Power Cable • Cigarette Charger • Start and End an Intercom Conversation • Volume adjustment by rot
SMH10 • Microphone Sponges • Hex Key (Allen Wrench) English • Velcro Pads INSTALLING THE SMH10 ON YOUR HELMET 1. Insert the back plate of the Speaker-Microphone clamp unit between the internal padding and external shell of the helmet. Please make sure that the microphone is located properly close to your mouth when you wear the helmet. Insert 2. Please adjust the direction of the microphone so that the triangular mark on the microphone is pointing towards your mouth.
SMH10 3. If you have any problem to clamp the Speaker-Microphone unit on the helmet for any reason, you may use the glued surface mounting adaptor to attach the Speaker-Microphone unit on the external surface of the helmet. • Remove the back plate of the Speaker-Microphone clamp unit by loosening the two screws with the enclosed Hex Key. Warning: Sena recommends the clamp unit over the glued surface mounting adaptor.
SMH10 5. To remove the main headset from the Speaker-Microphone clamp unit, hold the POWERING ON/OFF AND CHARGING English lower part of the Speaker-Microphone clamp unit with your thumb and gently press down the hook on the upper part of the headset main unit with your index finger until it clicks out. You may have to do this to charge up or to carry the headset To power on and off the headset, you don’t need to press and hold any button for main unit. several seconds.
SMH10 • Low Battery Warning When the battery is low, the blinking blue LED in stand-by mode turns to red PAIRING THE SMH10 WITH BLUETOOTH DEVICES and you will hear mid-tone triple beeps. Before using the SMH10 Bluetooth headset with any of Bluetooth devices for the first time, you need to do the pairing operation. It can be paired with Bluetooth mobile phones, Bluetooth audio devices such as MP3 or GPS, and with other SMH10 Bluetooth headsets.
SMH10 • Bluetooth MP3 Player Pairing PAIRING WITH SELECTIVE PROFILE: A2DP STEREO OR HANDSFREE English 1. The procedure is the same with the procedure of “Mobile Phone Pairing”, except the SMH10 must be paired as Stereo Headset. 2.
SMH10 3. Search for Bluetooth devices on your smartphone. The headset will be listed on your mobile phone as SMH10. PAIRING WITH OTHER SMH10 HEADSETS FOR INTERCOM CONVERSATION 4. Enter 0000 for the PIN. Some smartphones may not ask for PIN. The SMH10 can be paired with up to three other headsets for Bluetooth Intercom • HFP for Phone Call Only conversation. 1. Turn on the headset and press the Phone Button for 5 seconds until the LED 1.
SMH10 6. If a headset has multiple paired headsets for intercom conversations, the lastly A be Second Intercom Friend, and Third Intercom Friend. C B ** For example, after the paring procedures as above, the headset D is the First D Intercom Friend of the headset A, the headset C is the Second Intercom Friend of the headset A, and the headset B is the Third Intercom Friend of the headset A. Pairing A & B 5.
SMH10 USING THE SMH10 4. To transfer a call between the mobile phone and the headset, tap the Jog Dial during the phone conversation. You will hear a short/long beep when the call is transferred to the phone/headset. • Volume Adjustment 5. There are several ways to make a phone call: You can easily adjust the volume by rotating the Jog Dial. You will hear a beep when - Enter number on your mobile phone keypad and tap the Phone Button. The the volume reaches maximum or minimum level.
SMH10 2. To terminate an intercom conversation, single tap the Jog Dial. Any intercom flashing. When you do this, after first 5 seconds you press the button, you will see connection with any Intercom Friend will be terminated by a single tapping. the headset enters into the Mobile Phone Pairing sequence, but you have to keep A double or triple tapping will do nothing in this case. pressing the button for another 3 seconds until the red LED flashes rapidly. 2.
SMH10 reconnected. During the conference intercom, if you have an incoming mobile phone 3. The Second Intercom Friend (C) may join the intercom by making intercom call to call, terminate the conference intercom to automatically reconnect the mobile phone you (A). and receive the call. (A) 1. You (A) need to be paired with two other friends (B & C) for 3-way conference intercom. rin Pa i g rin (A) i Pa g First Friend (B) Second Friend (C) 4.
SMH10 1. Press and hold the Jog Dial for 8 seconds until the red LED turns on solidly. (B) and one with (C). When you do this, after first 5 seconds you press the Jog Dial, you will see 2. By single or double tapping the Jog Dial, you can terminate the intercom connection the headset enters into the Intercom Pairing sequence, but you have to keep with one of the two connected Intercom Friends accordingly.
SMH10 • Intercom Failure • Stereo Music When you try to start an intercom conversation with an Intercom Friend who You can listen to stereo music in either way: with the enclosed stereo audio cable is already having a 3-way conference intercom with other persons or a mobile or by Bluetooth wireless stereo. phone call, you will hear a low tone double beep signifying a busy signal. In this case, you have to try again later. 1.
SMH10 • To track forward or track back, rotate while pressing the Jog Dial clockwise or control music playback. So, you may not only adjust the volume but also use the counter clockwise. English Bluetooth audio device also supports the AVRCP, you can use the SMH10 to remotely functions such as play, pause, next track and previous track. • To adjust the volume, rotate the Jog Dial.
SMH10 Tip: Stereo Music by Bluetooth or 3.5mm audio cable Bluetooth music is available only when the MP3 jack port remains open. Please make sure the audio cable is unplugged from the clamp unit to play music by Bluetooth. FIRMWARE UPGRADE The SMH10 supports firmware upgrade function. Please visit SENA Bluetooth web site at www.senabluetooth.com to check the latest software downloads. • Reset to Factory Default Settings 1.
SMH10 BATTERY INFORMATION Button Description Duration LED Beep Phone Button + Jog Dial Power-on 1 sec Solid blue Ascending beeps Power-off Tapping Solid red Descending beeps remove the battery from the device as you may damage the device. The battery 5 sec Blue & red alternatively flashing High-tone multiple beeps can be charged and discharged hundreds of times, but it will eventually wear 5 sec Blue & red alternatively flashing High-tone multiple beeps out.
SMH10 MAINTENANCE AND CARE operation. These suggestions apply equally to the headset main unit, speaker-microphone The SMH10 should be treated with care and the following suggestions will help you protect your warranty coverage. 1. Do not use or store the device in dusty, dirty areas. Its moving parts and electronic components can be damaged. 2. Do not store the device in hot areas. High temperatures can shorten the life of electronic devices, damage batteries, and wrap or melt certain plastics. 3.
SMH10 CERTIFICATION AND SAFETY APPROVALS English DISPOSAL The crossed-out wheel bin symbol on the product, literature, or • FCC Compliance Statement packaging reminds you that all electrical and electronic products, This device complies with part 15 of the FCC Rules. Operation is subject to the batteries, and accumulators must be taken to separate collection following two conditions: at the end of their working life.
SMH10 interference by one or more of the following measures: • CE Declaration of Conformity - Reorient or relocate the receiving antenna. This product is CE marked according to the provisions of the R&TTE Directive - Increase the separation between the equipment and receiver. (99/5/EC).
SMH10 • Bluetooth License WAIVER AND GENERAL RELEASE English The Bluetooth® word mark and logos are owned by the Bluetooth SIG, Inc. and any use of such marks by SENA is under license. Other trademarks and trade names are those of their respective owners By using the SMH10 you will waive substantial legal rights including the right to The SMH10 is compliant with and adopts the Bluetooth® Specification 2.1+EDR sue. Please read the following carefully before using the device.
SMH10 capabilities and should not be misconstrued as if encouraging users to operate 1. You, your heirs, legal representatives, successors or assigns, hereby voluntarily the Device while actively involved in traffic.
SMH10 This warranty is limited to the repair and/or replacement, at SENA’s discretion, of cause serious disability; (b) these risks and dangers may be caused by the negligence defective or non-conforming Product, and SENA shall not be responsible for the of the manufacturers or its agents or any third party involved in designing or manufacturing failure of the Product to perform specified functions, or any other non- conformance the Device; (c) these risks and dangers may arise from foreseeable or unfo
SMH10 SHALL BE LIABLE FOR ANY OTHER DAMAGES, INCLUDING BUT NOT LIMITED TO DIRECT, INDIRECT, INCIDENTAL, SPECIAL OR CONSEQUENTIAL DAMAGES, WHETHER IN AN ACTION IN CONTRACT OR TORT (INCLUDING NEGLIGENCE AND STRICT LIABILITY), SUCH AS, BUT NOT LIMITED TO, LOSS OF ANTICIPATED PROFITS OR BENEFITS RESULTING FROM, OR ARISING OUT OF, OR IN CONNECTION WITH THE USE OF FURNISHING OF EQUIPMENT, PARTS OR SERVICES HEREUNDER OR THE PERFORMANCE, USE OR INABILITY TO USE THE SAME, EVEN IF SENA OR ITS DEALER HAS BEEN ADVISED
SMH10 English WARNING SENA informs that using this device in public traffic may not be authorized by the law. Please check your local law and use this device only out of public traffic such as private properties or closed circuits. If the simultaneous use of both ear speakers while riding a motorcycle is prohibited by your local law, please use only a single ear speaker while riding. SENA denies any liability should you choose not to respect this warning.
SMH10 28
www.senabluetooth.com V2.2.
