Specifications

SMH10
18
FIRMWARE UPGRADE
The SMH10 supports firmware upgrade function. Please visit SENA Bluetooth web
site at www.senabluetooth.com to check the latest software downloads.
• Reset to Factory Default Settings
1. To restore the SMH10 to factory default settings, press and hold the Phone Button
for 12 seconds until the LED shows solid red and you hear double beeps.
2. Then within 5 seconds, press the Jog Dial to confirm reset. The headset will be
restored to factory setting and switched off automatically.
3. If you don’t press the Jog Dial within 5 seconds, the reset attempt is canceled
and the headset returns to stand-by mode.
• Fault Reset
When the SMH10 is not working properly or is in faulty status with any reason,
you may reset by pushing the pin-hole reset button at the back of the headset
main unit. Insert a paper clip into the reset pin-hole and press the reset button
for a second with light pressure. The SMH10 will be switched off and you have to
turn on and try to use again. However, this will not restore the headset to factory
default settings.
Tip: Stereo Music by Bluetooth or 3.5mm audio cable
Bluetooth music is available only when the MP3 jack port remains open. Please make
sure the audio cable is unplugged from the clamp unit to play music by Bluetooth.