Operation Manual

SMH5

Connect the equipment into an outlet on a circuit different from that

to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

FCC RF Exposure Statement

The antenna(s) used for this device must be installed to provide a

separation distance of at least 20 cm from all persons and must not

be co-located or operating in conjunction with any other antenna or

transmitter.

FCC Caution

Any changes or modifications to the equipment not expressly

approved by the party responsible for compliance could void user’s

authority to operate the equipment.

CE Declaration of Conformity

This product is CE marked according to the provisions of the R&TTE

Directive (99/5/EC). Hereby, Sena declares that this product is

in compliance with the essential requirements and other relevant

provisions of Directive 1999/5/EC. For further information please

consult http://www.senabluetooth.com. Please note that this product

uses radio frequency bands not harmonized within EU. Within the EU

this product is intended to be used in Austria, Belgium, Denmark,

Finland, France, Germany, Greece, Ireland, Italy, Luxembourg, The

CERTIFICATION AND SAFETY APPROVALS

FCC Compliance Statement

This device complies with part 15 of the FCC Rules. Operation is

subject to the following two conditions:

This device may not cause harmful interference.

This device must accept any interference received, including

interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits

for a Class B digital device, pursuant to part 15 of the FCC Rules.

These limits are designed to provide reasonable protection against

harmful interference in a residential installation.

This equipment generates, uses and can radiate radio frequency

energy and, if not installed and used in accordance with the instructions,

may cause harmful interference to radio communications. However,

there is no guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful interference to

radio or television reception, which can be determined by turning

the equipment off and on, the user is encouraged to try to correct the

interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.