Specifications

SPH10S

again.

If this feature is disabled, the only way to initiate and terminate

an intercom conversation is to tap the Jog Dial.

1. Press and hold the Jog Dial for 8 seconds until the red LED

turns on solidly. When you do this, after first 5 seconds you

press the Jog Dial, you will see the headset enters into the

Intercom Pairing sequence, but you have to keep pressing the

Jog Dial for another 3 seconds until the LED turns to solid red.

2. To enable, tap the Jog Dial, then the blue LED flashes for 2

seconds and you will hear double beeps.

3. To disable, tap the Phone button, then the red LED flashes

for 2 seconds and you will hear a single beep.

However, even when this feature is enabled, if you terminate

intercom conversation manually by tapping the Jog Dial,

you cannot start intercom by voice temporarily. In this case,

you have to tap the Jog Dial to restart the intercom. This is

to prevent repeated unintentional intercom connections by

strong wind noise. If you tap the Jog Dial to start intercom

conversation, it is not terminated by 20 seconds of silence.

After turning SPH10S off and on, you can start intercom by

voice again.

Tip:

The Jog Dial is for any kind of Intercom related function, and

the Phone Button is for any functions of mobile phone. With this

reason, as far as intercom function is concerned, the Jog Dial

is used for a positive manner of action such as enabling, and

the Phone Button is for a negative manner of action such as

disabling. Vice versa for the mobile phone functions.

• Intercom Failure

When you try to start an intercom conversation with an

Intercom Friend who is already having a 3-way conference

intercom with other persons or a mobile phone call, you will

hear a low tone double beep signifying a busy signal. In this

case, you have to try again later.

• Intercom Reconnection

If your Intercom Friend goes out of range while having

an intercom conversation, you may hear static noise and