User Manual

Problem Solution
One of the antenna
reception indicators is
always off.
This indicates that one of the antennas is not operating
correctly. Replace the antenna on the side of the
missing level indicator.
Note: The receiver will operate with only one antenna,
but it will no longer operate as a true-diversity receiver.
You will run a greater risk of interference or dropouts.
The receiver or the
transmitter won’t operate.
LOCKED appears on the
screen.
Unlock either device by pressing and holding the Set
button to access the menu mode. Scroll to the LOCK
menu, and press the Set button to make the menu
selection blink. Use the Up/Down buttons to select
UNLOCK or ON W/LEVEL, and press the Set button
(see page 18).
Pilot tone is on, squelch
is on, but there is still too
much interference.
Rescan to find a frequency that is free of interference,
and sync your devices.
The receiver input signal
is too high/too low.
• Make sure you have selected the correct input level
on the transmitter (line/mic) (see page 19).
• Use the Up/Down buttons to adjust the transmitter
output level.
Everything is set properly,
but there is no signal from
the microphone.
• If you’re using a condenser microphone, make sure
phantom power is turned on.
• Make sure that pilot tone is activated on both the
receiver and transmitter. If pilot tone is active on
only one device, there will be no audio.
• Make sure the transmitter is not muted.
My input device is not
receiving signal from
the receiver.
Signal is too low/too high.
• Make sure you have made the correct connections
to your input device.
• Use the Up/Down buttons to adjust the receiver’s
main output.
• Refer to the input device’s user manual to enable
the recording function.
I installed fresh batteries,
but the battery meter
does not read full.
The meter shows that the
battery is fully charged,
but the battery runs out
sooner than expected.
Confirm that you have selected the correct battery
type. To change the battery type, see the Battery
section under Common Advanced Functions on
page 30.
▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪
Troubleshooting
34