User Manual

Basic Operation
▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪
4. Press the Up/Down buttons until [ SYNC YES ] appears on
the screen. Press Set to being syncing.
5. Position the receiver’s IR port so it faces the transmitter’s
IR port. This will sync the transmitter to the frequency
from the receiver. [
SYNC  ] will appear on the receiver’s
screen when the devices have been successfully synced.
6. When syncing is complete, confirm that the receiver and
transmitter are tuned to the same channel.
If [
SYNC ERROR! ] appears on the screen, repeat the previous
steps. Make sure the transmitter is turned on and that the IR
ports are facing each other.
Manual Channel or Frequency Selection
The frequency or channel selection can be initiated on either
device. To manually select the operating frequency, follow
these steps:
By Channel
The AWS-2000 operating frequency can be adjusted with
preset channels that are programmed to be intermodulation
free. If two AWS-2000 systems are operating in the same
space, selecting different channels will assure that the two
systems will not cause any disruptive intermodulation with
each other.
1. On the receiver, press and hold the Set button to enter
the menu.
2. Use the Up/Down buttons to scroll to [
TUNE ], and press
the Set button.
3. Use the Up/Down buttons to scroll to the [
CHANNEL ]
prompt, and press the Set button. The group number
will flash.
15