User Manual

7
Instructions
▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪
Mounting Instructions
A flange mount is included with the CXGN microphone for tabletop or desktop
installation. Follow these steps for mounting the flange to a surface.
1. Place the flange on the mounting surface in the desired location for the microphone.
2. Use a pencil to mark the flange holes and the center
hole on the mounting surface.
3. Remove the flange, and drill a center hole
approximately 1¾ inch (44.5 mm) in diameter
through the mounting surface for the XLR
connector.
4. With a small drill bit, drill three starter holes for the
attachment screws.
5. Replace the flange over the holes, and screw in the attachment screws until the
flange is securely flush against the surface.