User Manual

7
Mounting the Microphone
A mic clip is included for mounting your microphone on a mic
stand or boom pole with a 3/8″ or 5/8″ stud.
An adapter bushing comes installed in the mic stand. For
mounting on a 5/8″ stud, remove the bushing from the
mounting socket of the mic clip with a screwdriver or a coin.
Make sure to mount the microphone so that the mic clip is
not blocking the side ports of the microphone. Blocking the
side ports can affect the microphone’s performance and polar
pattern and make it more susceptible to picking up off-axis
sound.
The High-Pass Filter
Engage the high-pass filter in settings where there is audible
low-end noise such as air blowers, fans, or other ambient
noise. With this setting, frequencies below 180 Hz are
attenuated.
To select the high-pass filter, move the switch to the
( ) icon with a small screwdriver or the tip of a pen.
Mounting the Microphone / High-Pass Filter
▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪ ▪